Step 1
Cut the wires from the terminals on the electromagnet with the nippers.
It is recommended that you make a note of the wiring.
Step 2
A status indication. (Same lead wires and connections are cut.)
Step 3
Remove the nuts with the 7mm wrench.
Step 4
Pull out the electromagnets from the body.
Step 5
The state of the new electromagnets. One of the electromagnets has the soldered terminals. Strip off the coating each of the wires. (5mm from the end.)
Step 6
Secure the electromagnets to the body by the nuts. Use the 7mm wrench. Tie the wires in a bundle with a silicon tube.
Step 7
Connect the wires to the terminals.
Step 8
Solder the wires to the terminals. The wire requires a soldered connection. Touch the terminals to promote solderability from under side of the terminal with a soldering iron. This completes the electromagnet replacement procedure. Please go on the next operations.
