Step 1
REMOVAL OF ELECTROMAGNET
Cut the wire from terminals on the electromagnets with nippers.
It is recommended that you make a note of the wiring.
Step 2
Undo the frame screws and remove the SP switch.
Step 3
Remove the mounting nuts with the box driver. (7mm wrench)
Pull out the electromagnets from the pump body.
Step 4
FITTING THE ELECTROMAGNET
Secure the electromagnets to the body by the nuts.
Use the boxdriver. (wrench)
Step 5
Secure the SP switch to the frame by the screws.
• Be careful of the direction.
Step 6
Tie the wires in a bundle with a silicon tube. Strip off the coating each of the wires. (7mm from the end)
Connect the wires to the terminals.
The wire requires a soldered connection.
Step 7
This completes the electromagnet replacement procedure.
